decided to use regular deck screws after talking to a builder who has worked with Trex. PS: A friend at work is buidling a deck with ChoiceDek and has run accross the same issues. This is not recommended but is unavoidable since removing the joist hangers and rehanging is not an option.they are attached to solidly and I cannot get at all the nails attaching them. One other thing I am having to do is compensate for a joist that may be a bit to low by putting a space filler between the joist and the decking to keep level. All TimberTech decking lines and collections feature a grooved board option, so you don’t have to groove your own boards. How Do You Groove Composite Decking Easy you don’t. Square-shoulder is sometimes referred to as a solid board. That is how some were slightly higher than others.the joist hangers were not set exactly right for the particular joist they would be holding. Square-Shoulder A solid-edge board that allows for easy top-down installation. I then treated the shaved edges with wood preservative.Īs for the joist hangers, I am using them but I followed some instructions on a web site that said it was easier to apply all the joist hangers to the ledger board first then attache the ledger. ![]() I had to shave off the uneven seams and the severly crowned (up to 1/2 inch) joists to make sure they were even. I could not get all of these to line up properly with the joists they are between due to warps, crowns and different actual dimensions on some of the joists.Īs it turns out when I tried applying the Trex decking, being out even 1/4 inch is too much.the Trex bends to follow the level of the joist and will look poorly constructed not being level. I have put in 10.5" pieces of 2x10 between the joists in places for support and also for deck board end support (decking will be 45 degree angle to joists in places).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |